- To make your mascara waterproof, start with clean, dry lashes and apply two coats of waterproof mascara.
- Apply translucent powder to your lashes using an eyeshadow brush to set the mascara and create an additional barrier between your lashes and moisture.
- Reapply one coat of waterproof mascara over the top of the powder-dusted layer for added protection against smudging or running due to rain or sweat.
Don’t let a little rain ruin your look! This easy DIY trick lets you make your favourite mascara waterproof quickly. Whether it’s a special occasion or just an extra rainy day, this simple hack will keep your lashes looking long and luscious all day.
Here is a tutorial on how to make your mascara waterproof in simple 5 steps.
Are you tired of your mascara running off your eyes when the weather turns humid, or it starts raining? This not only appears messy but can also smudge your makeup.
Thankfully, there’s a way to make them waterproof. With some quick and simple steps, you’ll learn how to ensure that no matter what Mother Nature throws at you – your mascara will stay put! Let’s get started!
Start with clean, dry lashes. Before applying any product, use a makeup remover wipe to remove any remaining mascara from the previous day. This will help ensure that the new layer of mascara won’t clump up or run together when wet.
Apply two coats of waterproof mascara. Choose a mascara that is specifically designed for waterproof wear so that it will last even when exposed to water.
Start at the root of the lash and wiggle the wand as you move toward the tips for maximum length and definition. Allow each coat to dry fully before moving on to Step 3.
Apply translucent powder to your lashes using an eyeshadow brush. This will help set the mascara and create an additional barrier between your lashes and moisture from outside sources like rain or sweat.
Make sure to lightly dust off any excess powder with a clean makeup brush afterwards so that it doesn’t transfer onto your face later on.
Reapply one coat of waterproof mascara over the top of the powder-dusted layer for added protection against smudging or running due to rain or sweat.
Again, start at the base of each lash and work towards the tips in small strokes for maximum definition and length. Let this coat dry completely before moving on to Step 5.
Finish with a light coating of hairspray on your lashes —yes! Just make sure not to get too close so that you don’t end up with crunchy-looking eyelashes!
Spray from several inches away and allow everything to dry completely before opening your eyes wide again—now you’re all set!
With these five simple steps, you can easily turn any regular old non-waterproof mascara into an ultra-long-lasting formula that is resistant to water, sweat, and tears—you name it!
Now you can worry less about smudging or running throughout the day and enjoy beautiful bold lashes whether it’s sunny out or pouring rain!
It’s easy to turn almost any of your existing makeup into waterproof makeup. Before you apply, spray your cosmetic brushes with hairspray.
This will add extra staying power and help keep all of the ingredients locked together while you apply your makeup, leaving a smooth and lasting finish. You can also use a spray sealant; similar to hairspray, this product creates a protective layer over the applying surface.
Waterproof mascara usually contains waxes that make the formula very long-lasting and smudge-resistant. By layering a regular formula on, you may end up with clumpy or flaky lashes and decreased hold, making your application look messy after a short amount of time.
Instead, you could opt for formulas designed to resist smudging that is proven to maintain their hold better than regular formulas.
Setting spray often helps make cosmetics last longer and resist smudging, although the effect can depend on its formulation. In the case of mascara, it may not be enough to simply apply setting spray on top, as this could lead to clumps or messiness.
Being non-toxic and affordable, mineral oil is a great addition to your mascara routine for preserving the product. Another trick that can be used is adding a few drops of contact lens solution right before application.
